mike@devildogtools.com

Vacula 82-0000 VoltCheck Wireless Diagnostic Electrical Tester Vacula's VoltCheck Diagnostic Electrical Tester Works works without piercing the wire insulation and even through carpets, upholstery and plastic panels. With VoltCheck there is no need to disconnect a live circuit to check for open circuits. Other built-in transmitter features are an internal warning / protections system, low battery indicator and battery saver shutoff. Works on 12 - 24 VDC circuits. The Volt Check is a four-in-one diagnostic tester: Open circuit tester Ohmmeter Voltmeter Continuity tester VoltCheck consists of two units: Transmitter Receiver When checking for open circuits, the VoltCheck has two operations modes: Powered circuits Non-powered circuits In the powered circuit mode, the transmitter can be hooked up to the vehicle battery or powered fuse block. In this mode, the transmitter sends a mild signal through the circuit(s) that does not interrupt other electronic equipment. The receiver will flash red when held against a wire with complete circuit and stop where the circuit's open. When used on non-powered circuits the signal is generated through the internal power supply of the transmitter. The set includes: VoltCheck unit Battery connection leads Test leads Two AA batteries for the transmitter Two AAA batteries for the receiver Plastic carrying case for easy storage Specifications: Part number 82-0000 Signal generator Generates signal in 12V or 24V battery systems or in systems not connected to the vehicle system voltage Power supply External car battery or internal batteries Voltmeter 0 -  30 Volts Ohm mete 0 -  1000 ohms Continuity test Buzzer sounds at < 10 ohms Temp  range -14ºF to +122º F (-10ºC to +50º C)